Most people ask the question if it is possible to set up Cisco 1760 to synchronize with the PBX, where the E1 digital stream from the provider is connected. Such business voip solutions can increase the efficiency of the entire VoIP-system.
In order to synchronize, you need to specify the sources - external lines and register configurations for Cisco to generate data on its own.
To that end, all devices and software with versions 12.4 (23) should be allocated enough, with the data to be registered in the processor, the interface, ports, and NVRAM. You should also specify the 0x101 registers, with 1760_voip # sh diag to be set in the equipment. Then you need to register port numbers and Slot modules. Further, it is important to specify the data on the WIC / VIC Slot 1, with the installation of E1 Multi-Flex Trunk WAN daughter card. At the same time, you should specify the 1.0 version and highlight the S1760_voip (config) #conft code or other options.
After you have registered the configuration, it is necessary to specify the controller type. To do this, relevant data should be entered into the interface introduced, for example, voice-port x / x: 15. After that, you should pick up and enter time slots, with controller e1 to be turned on.
GoAntiFraud offers you to start a profitable GSM termination business! If you are interested in VoIP technology, we will help you start your own business, yielding a stable income. By purchasing our comprehensive New Business package, you will start making money immediately! We will give you full technical support at all stages of business.
To refine settings, beginners often visit some specialized Voip forums. There you can find information that the command is added to adjust the system clockto ensure that the router is applied via the right interface as the priority of the clock pulses and is repeated with a different priority for the interface, the timing hierarchy, with the indication of the network clock and Clock configuration. To do this, you need to check PBX settings and make sure the router is et up with internal synchronization of the command via ISDN emulation protocol.
The 1760 device uses the commands to adjust. Data are exported when you terminate voice. For fine-tuning you should open TDM / E1 / slot / port / voice / data / line, as well as features such as: 10/100 Modular Router w / 4 slots, 19-in Chassis, 32F / 64D and V3PN Bndl w / 1760- V / 128MB DR / 32MB FL / VPN Module / 4-Ch DSP. The interface should be specified as interface Serialx / x: 15, with a group of timeslots and settings to be removed at the same time.
When the configuration is incorrect, the sound/audio playback often lacks. Also, there may be problems with the connection and the correct messaging. To test E1, you should confirm Router #.
Are you interested in VoIP technology? Are you looking for a reliable start-up in the telecommunications sector? You will be interested in the opportunity to start a GSM termination business. You can get the maximum profit making the minimal investment! We offer a turnkey GoAntiFraud solution for beginners, which includes opportunities for efficient VoIP termination, as well as a set of equipment by GoIP, EjoinTech & China Skyline at low cost.
